By default Gramin watches set Run Activity profiles to AutoLap every mile or kilometre. This is great for steady runs as it gives us coaches great insights into how the run was executed.
However, for sessions where you are doing structured intervals like 6 times 4 minutes with 90 seconds recovery, you might press LAP at the start of the first interval, but then Autolap will set it’s own additional lap when you hit the next mile or Km marker. This can leave you confused as to how long you have left to run on an interval or even how much recovery you have left. For the coach it also makes interpreting the data difficult as laps will not equate to the intervals. So you can’t see average pace & heart rate, distance etc.
Solution.
For simplicity I just add a second Run profile so I have Run Auto & Run. This means I dont need to remember to turn Auto Lap On or Off each run.
The second benefit is that I set my default screen to contain the metrics I want :
Run Autolap: Timer, Distance, Current Heart Rate, Current Pace
Run (for Intervals) : Lap time, Heart Rate, Current Pace, Distance (Distance is useful but not important)
On secondary screens I put additional data that I may need, but not as a primary view requirement.
Finally : Workouts. If you use a structured workout that has been set up in your watch then it overrides autolap and creates laps from pre-determined intervals.